This is a 3D printed deck that doesn't ride like one. Every ply is printed cross-grain and then molded to shape, so the concave, the high kicks, and the pop feel like a real wood board. The graphic is printed into the deck instead of stuck on top, and the plies stack into a teal, purple, and yellow stripe down the edge.

It runs a popsicle shape with medium concave and high kicks, responsive enough for street and park. Each one is printed by 6oh5oh in small batches and built to ride daily.

Details

• Each ply printed to provide cross grains like a real wooden fingerboard, then molded to shape after printing
• Popsicle shape with medium concave and high kicks
• Sizes (approximate): Thin ~32mm, Medium ~34mm, Wide ~36mm. Length 97mm, wheelbase 58mm
• Printed in PLA (polylactic acid), a thermoplastic derived from renewable sources
• Standard truck mounting hole pattern, compatible with most fingerboard trucks and setups
• Custom design by Mark Howlett (6oh5oh), produced in small batches

Includes

• 1mm foam grip tape
• Deck only (trucks and wheels sold separately)

Note: Due to the 3D printing process, slight variations in finish may occur between decks.

Disclaimer: 3D printed materials may be sensitive to heat. Avoid prolonged exposure to direct sunlight, enclosed hot environments, or other heat sources, as this may cause warping or deformation.

Warning: Choking hazard, small parts. Not for children under 3 years.